Neumann Monitor Alignment Kit 1

1424.27 GBP*

Description

Set of Neumann MA 1 measuring microphone & KH 750 DSP subwoofer. Perfect complement to KH 80 / KH 120 / KH 310 / KH 420. Neumann Monitor Alignment Kit 1 Overview: MA 1 Measuring microphone KH 750 Subwoofer Perfect basis for setting up a frequency-corrected loudspeaker system Direct control of the KH 750 by the software DSP preset is stored in the KH 750; calibration without computer possible. Compatible with all analog and digital Neumann loudspeakers (loudspeaker configuration is queried by the software during calibrate) Stereo subwoofer setups possible Setup with free Neumann Automatic Monitor Alignment software Makes it possible to assemble a modern high-end system for recording studios and hi-fi enthusiasts With the KH 750, the MA 1 system is compatible with all analog Neumann loudspeakers. State-of-the-art technology for optimally adapted sound With Neuman's MA 1 calibration system you get a stationary loudspeaker system with perfectly optimised frequency, phase and impulse response according to scientific criteria. Due to its independence from a computer, such a system is also of interest to discerning hi-fi connoisseurs and is even a fairly low-priced alternative to high-end systems in the hi-fi sector. Set-up effort that pays off. For correct operation of the Neumann Monitor Alignment Kit 1, in addition to the included Neumann subwoofer, a pair of Neumann loudspeakers is required, as well as a LAN cable for control of each DSP device, 2 XLR cables for connection of the loudspeakers, and 1 additional XLR cable for the measuring microphone during the calibration process. Your DSP-controlled Neumann devices are connected to your computer, if necessary by means of a network switch, and an appropriate number of LAN cables. The LAN network is only required for the calibration process; after calibrate, the EQ and delay curves are stored in the DSPs and the network can be disconnected again. Neumann's software guides the user through an automated sequence of calibration steps. Different setups - one software The MA-1 measurement microphone is operated for calibration at the microphone input with 48V phantom power of the same audio interface to which the loudspeakers are connected. If the system is to be set up using the digital input on the subwoofer/speaker, a digital audio output is also required on the interface. However, the use of the digital inputs is only supported with the LAN-capable KH 80 DSP. The digital inputs of KH 120 D / KH 310 D drive a DSP module, which is not required for the otherwise analogue speakers in combination with the Monitor Alignment Kit. In this case, use the analogue XLR connectors. Finally, the generated curve is displayed and can be adjusted. All in all, there are several possibilities for the connection from the interface to the box(es): AES/EBU: The digital output in XLR format requires a line with 110Ohm impedance, but the unbalanced AES3 input with BNC socket at the box requires a signal with 75Ohm source...